It is too easy to lose your work if you rely only on the device's flash memory. This means that if you are using a different version of firmware then theĪutocompleter may offer some names that are not present on your device and miss some that are.Īlthough Thonny allows you to work without saving anything locally, for serious work we recommend keeping master copies of your scripts in your main computer (preferably under version control) and copy them to the device as required (File => Save copy as). This is based on the API-s scraped from specific devices with specific MicroPython / CircuitPython versions (different for each backend type). You can also open files by double-clicking them in Thonny's file browser (View => Files).ĭuring editing your scripts, Thonny offers autocomplete (performed by the jedi library).
Note that Thonny always synchronizes file writes - this reduces the risk of corrupt files when you accidentally reset your device without proper eject right after saving a file onto its USB drive. Same goes to save commands ("Save", "Save as", "Save copy as"). When you have a MicroPython back-end selected, "File => Open" allows you to open a file either from local disk, device's USB drive, or "directly" form your device's file system. On your device yet, then see below for the section about firmware installation.) Editing scripts (If you don't have suitable MicroPython (or CircuitPython) firmware installed One board connected, then you could leave this setting for automaticĪfter you press "OK", Thonny's shell should present either the prompt of yourĭevice's REPL or the output of the script which is currently running on your device. Now you can specify the port your device is connected to. NB! Since version 3.3 you can also use the back-end switcher in the lower-right corner of Thonny's main window. Specific back-end, then try "MicroPython (generic)".
The type of your device from the drop-down list. In Thonny, open the back-end manager (Run → Select interpreter) and choose
#Thonny install adc0832 library serial#
If required, install the necessary drivers for serial communication. Configurationīefore continuing, make sure that you have your device attached to a USB port. See the bottom of the page for historical notes. This page describes MicroPython support since Thonny 3.2.
0 kommentar(er)
